Installation directions of lightweight facade decoration from Decolight

1.  Align all the surfaces for decoration’s installation. This can be done by means of stucco or a facade glue used for decoration’s installation (with small volumes of alignment).
2. Partition all the horizontal and vertical lines with a plumb and a level.
3. Dilute and apply glue to the back surface of the profile (it's best to do it with a spatula-comb). You should use construction glue for installation of polystyrene plates in the systems of "wet" facade (Knauf Sevener, Termokreps PPS, Atlas Stopter K-20, Ceresit Ct 85, Stayrofiks Terraco and similar products).
4. It is necessary to press down the profile to the sticking surface, make a few small reciprocating motions of the element and set it to the desired position. To fix the profile in the desired position, you should use screws, anchors or expansion bolt, drilling through the profile (do not use the impact properties of drill or punch) or pre-install horizontal strips (for pasting profiles horizontally).
5. After drying of the glue you should process the joints, using plaster-adhesive or plaster mixes based on cement, you can also use acrylic and polyurethane sealants. 
6. Paint the set profiles, using the recommended program of paint from the manufacturer It is possible to use any facade paints designed to cover cement-containing bases. 

During the installation the connection between the separate segments of profiles must be filled with glue and it is also recommended to get pieces of stucco mesh into them for improving the joints, so that the part of it lays next to the wall and the other part is in the joints between the elements.